Related Manuals for iQe SIMPLICITY Series
Summary of Contents for iQe SIMPLICITY Series
- Page 1 25-30-35-20 t-25 t-30 t EnsurE that thEsE instructions arE lEft for thE usEr aftEr complEtion of thE BEnchmarK sEction plEasE rEad thE important noticE within this guidE rEgarding your BoilEr warranty...
- Page 2 IMPORTANT NOTICE For the first year all of our appliances are protected by our manufacturer’s guarantee which covers both parts and labour. As you would expect from , it is our aim to provide our valued customers with the best in after sales and service.
- Page 4 THE BENCHMARK SCHEME The manufacturer is a licensed member of the Benchmark Scheme which aims to improve the standards of installation and commissioning of domestic heating and hot water systems in the UK and to encourage regular servicing to optimise safety, efficiency and performance. Benchmark is managed and promoted by the Heating and Hotwater Industry Council.
-
Page 5: Table Of Contents
IPX4d 25: Gas Council number 47-283-41 20 T : Gas Council number 41-283-35 30: Gas Council number 47-283-42 25 T : Gas Council number 41-283-36 35: Gas Council number 47-283-43 30 T : Gas Council number 41-283-37 These appliances comply with the S.E.d.B.U.K. scheme, band “A” CONTENTS OPERATING INSTRUCTIONS FOR THE USER INTRODUCTION . -
Page 6: Operating Instructions For The User
APRE OPERATING INSTRUCTIONS FOR THE USER APRE THE GAS SAFETY (INSTALLATION AND by the appliance detecting water flow to start up the boiler again, adhere strictly USE) REGULATIONS 1996. (providing that the flow rate is above 2 to the following instructions: open the It is the law that all gas appliances l/m - 0.5 gal/min). -
Page 7: Errors And Solutions
APRE 1.3.2 Regulation C.H. temperature (fig. 25) To set the temperature of the water for Circuito heating, press the key of the controls Heating circuit 2 riscaldamento 2 Circuito (2). The first time the riscaldamento 2 key is pressed, the SET of heating circuit Circuito 1 is selected. -
Page 8: Minimum Clearances
luminous bar becomes red. Descriptions of the errors with the relative alarms and Circui Circuito solutions are given below: riscald riscaldamento 2 – ALL 01 Seek help and advice from a qualified engineer. Circui Circuito riscald riscaldamento 3 (impia (impianto tre zone) zone) –... -
Page 9: Ventilation
PROGRAMMED Boiler The mains supply must be fused at 3 to clean the appliance outer casing. used until the fault has been rectified by Boiler ON (I) amp. DO NOT use abrasive cleaners. a competent person. WARNING: VENTILATION SAFETY IF A GAS LEAK IS SUSPECTEd OR EXISTS, TURN OFF THE GAS SUPPLY TO If the appliance is installed in a cabinet, it It is essential that the instructions in... -
Page 10: Digital Time Clock (Code 8092271)
dIGITAL TIME CLOCK - Code 8092271 When the selector is in the “AUTO” position, boiler fun- ctioning is automatically controlled on the basis of the – deleting one or more programs temperature levels and time periods set. The second The on and off time must be deleted for each program to be deleted. - Page 12 Ba22 8rt phone: 0800 0152252...
Need help?
Do you have a question about the SIMPLICITY Series and is the answer not in the manual?
Questions and answers