Husqvarna DS 500 Operator's Manual page 9

4. Install the drill stand with the nut.
To attach the product with a Husqvarna
vacuum plate
WARNING: Do not use the product in
combination with the vacuum plate when
you drill in walls or ceilings.
WARNING: The support surface must be flat
and of good quality. The product can
become loose if the vacuum plate cannot
seal fully against the surface.
WARNING: Use of vacuum plate is only
recommended together with these
Husqvarna drill motors: DM 200, DM 220,
DM 230, DM 280, DM 340, DM 400. Use of
other drill motors can cause the product to
become loose.
1. Attach the product to the vacuum plate with the bolt.
922 - 004 - 27.09.2019
2. Loosen the level adjustment screws. They must be
above the bottom of the vacuum plate.
3. Connect the vacuum hose and start the pump.
CAUTION: The minimum pressure must
be -0.85 bar to seal the vacuum plate
tightly to the surface.
4. Tighten the level screws until you feel pressure on
the screw.
WARNING: The level adjustment screws
must touch the surface when when you
use the vacuum plate. If not, the vacuum
plate can come loose.
To attach the drill stand with a rod that has a
thread
Use an all through rod if it is not possible to attach the
drill stand to the wall or ceiling with an expander bolt.
Use washers and nuts to tighten the all through rod.
9