Sleep Timer; C Copying A Video Tape - Sylvania SRC2109E Owner's Manual

3
Set wake up time
Press the PLAY/K or STOP/L but-
ton until to point to "TIME".
Press the F.FWD/B or REW/s
button until your desired wake up
time appears.
Each additional push will increase (or decrease) the
time by 10 minutes.
4
Exit the Wake Up Timer setting
Press the MENU button on the remote control to
return to TV mode.
TO CANCEL THE WAKE UP TIMER
Press the WAKE-UP/SLEEP button on the remote
control once, and confirm "ON/OFF" is pointed.
Press the F.FWD/B or REW/s button until [OFF]
appears.
You can make copies of video tapes made by friends
or relatives for your enjoyment.
WARNING: Unauthorized recordings of
copyrighted video tapes may be an
infringement of copyright laws.
Connect your TV/VCR and a Source (Playing) VCR
using the following diagram.
AUDIO VIDEO
Audio/Video
adapter cable
(not supplied)
WAKE UP ON/OFF
TIMER TV/TAPE
B TIME
COPYING A VIDEO TAPE
POWER
[The TV/VCR]
REC
[Ex: Source (playing)
VCR or camcorder]
VIDEO
OUT
IN
AUDIO

SLEEP TIMER

The Sleep Timer function turns off the TV/VCR
without using the POWER button after a desired
period of time.
NOTE:
[ON]
•
[TV]
This function does not operate during Recording
[12:00AM]
mode.
1
Select "SLEEP TIMER"
Press the WAKE UP/SLEEP button on the remote
control until "SLEEP TIMER" appears.
2
Set sleep time
Press the PLAY/K, STOP/L,
F.FWD/B or REW/s button until
your desired sleep time appears.
Each additional push will increase
the time by 30 minutes up to 120 minutes.
Press the MENU button on the remote control to exit
the Sleep Timer setting.
TO CANCEL THE SLEEP TIMER
Press the WAKE-UP/SLEEP button on the remote
control until "SLEEP TIMER" appears.
To view the time left for sleep timer, press the
WAKE-UP/SLEEP button twice, then press the
MENU button on the remote control to exit the sleep
timer setting.
1)Insert a pre-recorded video cassette into the Source
(Playing) VCR or camcorder.
2)Insert a blank video cassette, or one you want to
record over, into the TV/VCR's cassette compart-
ment.
3)Press the SPEED button on remote control for the
TV/VCR to select the desired recording speed
(SP/SLP).
4)Press the CHANNEL K or L button on the
TV/VCR until "AUX" appears on the screen.
NOTE: "AUX" is found below the lowest memo-
rized channel. (Example: CH2)
5)Press the RECORD button on the TV/VCR.
6)Begin playback of the tape in the source (Playing)
VCR or camcorder.
NOTE: For best results during dubbing, use the
TV/VCR's front panel controls whenever possible.
The remote control might affect the source (Playing)
VCR's playback operation.
- 23 -
SLEEP TIMER [2:00]
EN
9J27