Table of Contents
Advertisement
Gate A20 Option
Select if chipset or keyboard controller should control Gate A20.
The Choices:
Fast (Default)
Normal
Typematic Rate Setting
When a key is held down, the keystroke will repeat at a rate determined
by the keyboard controller. When enabled, the typematic rate and
typematic delay can be configured.
The Choices: Disabled (Default) / Enabled
Typematic Rate (Chars/Sec)
Sets the rate at which a keystroke is repeated when you hold the key
down.
The Choices: 6 (Default) / 8 / 10 / 12 / 15 / 20 / 24 / 30
(This option can be set only when "Typematic Rate Setting" is enabled.)
Typematic Delay (Msec)
Sets the delay time after the key is held down before it begins to repeat
the keystroke.
The Choices: 250 (Default) / 500 / 750 / 1000
(This option can be set only when "Typematic Rate Setting" is enabled.)
Security Option
This option will enable only individuals with passwords to bring the
system online and/or to use the CMOS Setup Utility.
The Coices:
System
A password is required for the system to boot and is
also required to access the Setup Utility.
Setup (Default) A password is required to access the Setup Utility
only.
This will only apply if passwords are set from the Setup main menu.
APIC Mode
Selecting Enabled enables APIC device mode reporting from the BIOS
to the operating system.
The Choices: Enabled (Default) / Disabled
Lets chipset control Gate A20.
A pin in the keyboard controller
controls GateA20
A690E-IS
31
Advertisement
Table of Contents
