Pioneer VSX-2016AV-S Service Manual page 270

1
QQ
3 7 63 1515 0
A
8 Component control buttons
The main buttons ( , , etc.) are used to control a
component after you have selected it using the input
source buttons.
The controls above these buttons can be accessed after
you have selected the corresponding input source button
(for example DVD, DVR1 or TV). The following controls
can be accessed when listening to the built-in tuner:
MPX – Switches between stereo and mono reception
of FM broadcasts. If the signal is weak then switching
B
to mono will improve the sound quality.
DISP – Switches between named station presets and
radio frequencies.
9 STATUS
Press to check selected receiver settings.
10 MULTI OPE
Use this button to perform multi operations.
11 SHIFT
Press to access the controls outlined in white boxes (for
example, INPUT SELECT
C
selected input source in the remote control LCD.
12 SOURCE
TE
L 13942296513
Press to turn on/off other components connected to the
receiver.
13 Character display (LCD)
This display shows information when transmitting
control signals.
The following commands are shown when you're setting
the remote to control other components (see Controlling
D
the rest of your system):
SETUP – Indicates the setup mode, from which you
choose the options below
PRESET – See Selecting preset codes directly.
LEARNING – See Programming signals from other
remote controls.
MULTI OP – See Multi Operation and System Off.
SYS OFF – See Multi Operation and System Off.
DIRECT F – See Direct function.
RENAME – See Renaming input source names.
ERASE – See Erasing one of the remote control
button settings.
E
RESET – See Resetting the remote control presets.
READ ID – See Confirming preset codes.
www
F
270
1
http://www.xiaoyu163.com
2
), or to display the currently
x ao
y
. i
VSX-2016AV-S
2
http://www.xiaoyu163.com
3
8
14 RECEIVER
Switches the remote to control the receiver (used to
select the green commands above the number buttons
(ANALOG ATT, etc)). Also use this button to set up
surround sound . With SHIFT, this selects the multi-room
control.
15 VOL +/–
Use to set the listening volume.
16 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
17 Receiver controls
SIGNAL SEL – Use to select an input signal.
SBch – Use to select the surround/virtual back
channel mode.
STEREO – Switches between direct and stereo
playback. Direct playback bypasses the tone controls
and any other signal processing for the most
accurate reproduction of a source.
THX – Press to select a Home THX listening mode.
STANDARD – Press for Standard decoding and to
switch between the various 2 Pro Logic IIx and
Neo:6 options.
ADV.SURR – Use to switch between the various
Q Q
3 6 7 1 3
surround modes.
18 PHASE – Press to switch on/off Phase Control.
MCACC – Press to switch between MCACC presets.
S.DIRECT – Press to select Auto Surround or
Stream Direct listening.
u163
.
3
4
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9