Fcc Notice; Wireless Module Specifi Cations; Open Source Software Notice - Kenmore 796.8156 Series Use & Care Manual

FCC NOTICE

(for transmitter module contained in this product)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment to an outlet on a circuit
diff erent from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation of the device.
Any changes or modifi cations in construction of this
device which are not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This equipment should be installed and operated with
a minimum distance of 20 cm (7.8 inches) between
the antenna and your body. Users must follow the
specific operating instructions for satisfying RF exposure
compliance.
IMPORTANT SAFETY INSTRUCTIONS
WIRELESS MODULE SPECIFICATIONS
Model LCW-004
Frequency 2412–2462 MHz
Range
Maximum IEEE 802.11b: 22.44 dBm
Output
IEEE 802.11g: 24.68 dBm
Power
IEEE 802.11n: 24.11 dBm

OPEN SOURCE SOFTWARE NOTICE

To obtain the source code that is contained in this product
under LGPL and other open source licenses, visit
http://kenmore.com/opensource. In addition to the source
code, all referred license terms, warranty disclaimers, and
copyright notices are available for download.
5