Table of Contents
Advertisement
Important Information
General
These Installation instructions contain
important Information which must be
observed in order that the extractor
hood can be installed and operated with-
out risk or difficulties. Keep these Instal-
lation instructions in a safe place for
subsequent use. Follow the instructions
of the cooking appliance manufacturer
for Installation of extractor hoods. The
assistance of another person will facili-
tate Installation. Replace defective parts
with original spare parts or with parts
named by the manufacturer.
Note: If extractor hoods feature external
fan motors, the Installation of the fan
motor can be found in separate installa-
tion instructions.
Safety instructions
Dinger
Installation, connection, startup and re-
pairs may be carried out by technicians
only. Technicians can specify a suitable
attachment and exhaust air conduction
for the extractor hood. The attachment
must be suitable for the weight of the
extractor hood and for the load on the
wall. Observe the pullout values of the
supplied wall plugs. These have the
following values depending on the wall:
10 mm wall plugs:
Concrete B25
Brick MZ20
Solid calcium silicate brick KSV204.8 kN
If the wall is made of other uncertain
materials, consult a building specialist,
e.g. a structural engineer or an architect
to ensure t hat the extractor hood can be
installed securely.
Risk of injury
The hood structure may have sharp
edges caused by the manufacturing
process. Wear protective gloves during
installation.
Risk of electric shock
The mains voltage must correspond with
the specifications on the rating plate. The
rating plate is situated near the filters
inside the hood. Connect the extractor
hood to a correctly installed earthed
socket only. The socket must be easily
accessible following installation so that
the extractor hood can be isolated if re-
quired. If the extractor hood is to be per-
manently connected (e.g. if there is no
appropriate socket), it may be connected
to the mains by an electrician only. If the
extractor hood is to be permanently con-
nected, it must be connected to a single
electric
Switches with a contact opening of at
least 3 mm and all-pole switches, e.g. LS
switches and contactors, are regarded as
disconnectors. Before connecting the
extractor hood to the power supply, dis-
connect the mains circuit(s). Before drill-
ing fixing holes, ensure that there are no
electric cables which could be damaged
by the drilling. When preparing the power
supply connection, ensure that the ex-
tractor hood can be connected without
difficulty.
Observe local regulations.
Exhaustair conduction for exhaust airmode
The exhaust air must not be conducted
into a chimney which is used to remove
exhaust gases from appliances which
use fuel (e.g. gas). Observe the official
regulations for the removal of exhaust
air. When preparing the exhaust air
route, ensure that the extractor hood can
9.4 kN
be connected without difficulty. The ex-
5,2 kN
haust air hose must not be kinked.
Solid fuel fireplaces
The extractor hood must not be installed
above a solid fuel fireplace which is a fire
hazard (e.g. flying sparks) unless the fire
-place has a sealed, non-removable
cover.
circuit
with
disconnector.
en
15
Advertisement
Table of Contents
