4. Controller Operation
4.1 Controller Displays (fig. 10)
The controller of the RATIOfresh freshwater station features
a permanently backlit LCD display (5) with 2 lines, LCD- Dis-
play (5), 4 LEDs depicting information about the operating
status of the station (1) to (4) and 3 control buttons (6), (7),
and (8). Open the cover of the controller by unscrewing the
four Phillips screws (9)!
IMPORTANT
Only open the controller housing cover when unit is de-
energized! Only qualified technical personnel!
●
A steady green LED (1) is based on the output of the pri-
mary circuit pump (max. output), with longer green
phases (medium output), or with shorter green phases
(low output).
●
LED (2) indicates the operating status of the circulation
pump (if connected) in the same manner.
●
A steady green LED (3) indicates that the external
switching output to activate the auxiliary heating (only
disinfection function) is closed.
●
A steady red LED (4) indicates that the disinfection tem-
perature was less than required during the disinfection
time or that the primary circuit temperature fell below
the required temperature level.
●
Use keys < (6) and > (8) to browse within the info level
and depict all current temperatures and pump outputs.
4.2 Controller Settings (fig. 10)
●
Use key ■ (7) to switch from the info level to the menu
level.
●
Use keys < and > to select the desired setting menu.
●
Press key ■ to switch to the value level where the set
nominal values are listed in square brackets.
●
Select the desired menu item with the < and > keys and
release for change with the ■ key: the square keys are no
longer depicted.
●
Use the < and > keys to set the new nominal value and
press the ■ key to save.
●
Exit the menu level with the menu item "END ... " and se-
lect with the < and > keys and press the ■ key. This re-
turns you to the next higher level.
EN-RATIOfresh-250-400_TI-MA-0809-11214900
10
& C
e r
g n
W a
Info Level
Temp. Warmwasser
Temp. hot water
Actual:
Ist:
Menu level
Settings:
Temp. Warmwasser
HOT WATER
Ist:
Value level
Pump 1 mode
[AUTO]
previous
Temp. hot water
Nominal:
Setting level
Temp. Warmwasser
Temp. hot water
Nominal:
Ist:
Temp. hot water
Temp. Warmwasser
Nominal:
Ist:
Figure 10 Controller display and controller configuration
1 LED, primary circuit pump; 2 LED, circulation pump; 3 LED, Aux. heat-
ing activation; 4 LED, temperature; 5 LCD display; 6 Left key; 7 Center
key; 8 Right key; 9 Phillips screws.
1
2
3
4
5
o
8
7
6
9
46°C
47°C
Settings:
End ...
47°C
End ...
post
Temp. hot water
[45]°C
Nominal:
[50]°C
[45]°C
47°C
[50]°C
47°C
13