Table of Contents
Advertisement
1-3. Electrical Alignment
Resetting the Control Data
(1) While holding the CURSOR ON button down, push up the DISPLAY switch from ON to PAGE.
The Maintenance menu appears on the monitor screen.
(2) Set the arrow (8) to the "Reference Store" line by turning the VF DETAIL control and press the
CURSOR ON button. The Reference Store menu appears.
(3) Set the arrow (8) to the "All Preset" line by turning the VF DETAIL control and press the
CURSOR ON button. The control data will be reset.
(4) Set the DISPLAY switch to OFF.
Setting the System Setup (NTSC only)
(1) While holding the CURSOR ON button down, push up the DISPLAY switch from ON to PAGE.
The Maintenance menu appears on the monitor screen.
(2) Set the arrow (8) to the "System Setup" line by turning the VF DETAIL control and press the
CURSOR ON button. The System Setup menu appears.
(3) Set the arrow (8) to the "Select UC/J" line by turning the VF DETAIL control and press the
CURSOR ON button to select "UC". (Every time you push this button, it changes between UC and J.)
(4) Set the DISPLAY switch to OFF.
R
G
POWER
FILTER
LOCAL
H-POSI
ND
CC
WIDTH
3
C
2
B
4
D
1
A
E
5
CENTER
SAFETY
UP TALY
MARKER
ZONE
ON
ON
ON
OFF
OFF
OFF
DISPLAY switch
〈 BVP-700/700P rear panel 〉
1-8 (E)
RET 2
RET 1
B
1
V-POSI
HEIGHT
STORE
CURSOR
1
2
3
VF
DETAIL
PinP
MIX VF
DISPLAY
PAGE
POSITION
ON
ON
ON
ON
OFF
OFF
OFF
OFF
VF DETAIL control
CURSOR 1/2/3 button (Use to cancel)
CURSOR ON button
ON
CALL
BKP-7090
Advertisement
Table of Contents
