Table of Contents
Advertisement
1-2. Installing the BKP-7090 in the BVP-700/700P
(6) Secure the MB-764 board with the supplied eight screws (PSW3 x 6).
n
Tighten the screws across the connector in order of 1 to 2, then tighten the remaining screws.
When tightening the screws, take care not to drop them into the camera.
(7) Place the label (1) on the partition as shown in the figure.
(8) Unclamp the harnesses and route them as shown in the figure. Connect all the connectors that were
removed in step (4).
n
Harness routing must be changed because connectors configuration for the MB-764 board differs
from that for the former MB-430 board.
CN31
CN21
Partition
MB-764
1-4 (E)
PSW3 x 6
CN16
CN23
CN24
Label(1)
VF CN23
CCD CN24
STAND ALONE CN15(OPTION)
*
CN25(black)
*
CN28(red)
*
CN29(blue)
CN17
CN18
MB-764
PSW3 x 6
2
PSW3 x 6
PSW3 x 6
1
PSW3 x 6
Harness Arrangement
MB-430 board
CN32
(Option)
CN23 CN24
CN12
MB-764 board
CN13
CN23 CN24
* RF cable
Clampers
(Option)
BKP-7090
Advertisement
Table of Contents
