Linear Power Cover Instruction Manual
Power Supplies Affected
SLS-05-030-1T, SLS-12-017T, SLS-24-012T
What's Included
• Part A Cover
• Two Plastic Screws M3x6 mm
• Two Self-tapping Screws M3x6 mm
• Instruction Manual
Assembly Instructions for Cover Installation
Self-tapping screws (2 qty)
M3x6 mm
1. Position the Part A Cover so that it overlaps the exterior surface of the
Power Supply Chassis.
2. Line up the Part A Cover mounting holes with the Power Supply Chassis
mounting holes. Be careful not to pinch the wires.
3. Secure with the provided screws as shown in Figure 1.
FIGURE 1
*
*
Plastic screws (2 qty)
M3x6 mm
*Must use plastic only
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Model Number: SLCASA-CVR
Assembly Instructions for OVP
FIGURE 2
1. Locate the mounting holes as shown in Figure 2.
2. Attach SLO-12-000-TB tightly against the inner side of the cover.
3. Position the mounting holes and tighten the screws with 8 kg torque.
4. Assemble the two wires coming out of the SLO-12-000-TB. On the terminal
block, the white wire goes to the "+" and the black wire goes to the "-".
Notes
1. Be careful while assembling the cover, so that no parts on the PCB are
damaged.
2. When tightening the screws, make sure the torque is 8 kg.
3. Derate power supply by 15% with cover installed.
Part Number: A272-108 Rev 3
September 22, 2008