Advertisement
REDA SOLAR User Manual
RED/GREEN/BLUE STATUS LIGHT
*After turning the REDA SOLAR ON. A Red/Green/Blue status light will cycle for two seconds
then stop. This signals the REDA SOLAR system is OK and will work in the default operation of
0%+100% sensitivity power surface material. Please see package contents before installation.
*After 1 minute of being ON a BLUE light will start to flash slowly. This signal means the REDA SOLAR is in a
charge state, the solar panel is connected and operated as it should.
IMPORTANT:
If the BLUE light flashes quickly after 1 minute, check the polarity connection between the solar panel and
REDA SOLAR: positive cables together and negative cables together with a firm stable contact made.
TESTING
To simulate the REDA SOLAR operation during daylight hours Disconnect or cover the Solar Panel (This
signals no voltage present to the REDA SOLAR, and will simulate night operation) – Now turn REDA
SOLAR ON. The Red/Green/Blue status lights will cycle for two seconds then stop. After 40 seconds,
move in proximity of the microwave sensor, once detected by the microwave sensor the light will
operate with 100% light output (default setting) then will turn off automatically after 30 seconds.
PLEASE NOTE:
The default setting is Mode A with 0% power (No Light Output) and 100% Light Output when a person is in
proximity. You can press buttons B, C or D or 20%, 40%, 80% to turn light ON immediately to check light condition.
USING THE REMOTE
The remote uses microwave (IR) technology and needs to be used in the same way as a TV –You must point
the remote directly at the REDA SOLAR to send a command. After pressing a button on the remote control,
you will see a GREEN + BLUE light for two seconds. That signals a command has been received successfully.
Note: Refer to manual for remote control functions and programming.
HOW TO FIX COMMON PROBLEMS
BLUE LIGHT NOT VISIBLE
Once you have followed the steps under General Operation, if the Blue light is not
flashing at all, please double check that there is a solid and stable connection between
the REDA SOLAR and the Solar Panel, and that the polarity is correct.
• Meter the voltage from the solar panel to the MC4 connectors. Ensure the voltage
is no less than 15Vdc and that the connectors inside MC4 are not loose.
GREEN SIGNAL LIGHT FLASHING FAST
• If the GREEN light is flashing-fast, this signals an over-discharged battery state. In this situation,
carry out a full charge using the solar panel sized for the installed REDA SOLAR.
This can take up to 6 hours for a full charge depending on panel size.
LED IT COMPANY LIMITED
Room A, 21/F, Gaylord Commercial building,
114 -118 Lochkart Road, Wanchai, Hong Kong
Contact : sales@leditinternational.com
6
REDA SOLAR User Manual
Subject to change without notice.
Advertisement
