Advertisement
REDA SOLAR User Manual
REMOTE CONTROL
Modes Zone
Time Zone
ON/OFF override button. 100% Light Output
Auto Function (Not Used). By Default Auto Function is programmed ON. (Auto OFF During Day, Auto ON During Night)
Test Function. Light will operate for 20 seconds.
- The red indicator light will operate inside the end-cap if the battery is low / over-discharged.
Constant light mode
Light Output 0%. When sensor triggered - Light Output 100% for 1 minute.
Light Output 30%. When sensor triggered - Light Output 100% for 1 minute
Light Output 50%. When sensor triggered - Light Output 100% for 1 minute.
Light Output 100% (First 6 hrs). Light Output 50% (Second 6 hrs) - When sensor is triggered - Light Output 100% for 1 minute.
* Helpful Hint. Press "D" and a Time Setting (e.g.7H) = 100% for 3.5 hours then 50% for next 3.5 hours + 100% with sensor.
Time Setting mode
LED IT COMPANY LIMITED
Room A, 21/F, Gaylord Commercial building,
114 -118 Lochkart Road, Wanchai, Hong Kong
Contact : sales@leditinternational.com
Magic Remote Control Manual
The magic remote control is specially developed for solar luminaries. It offers a combina-
tion of many lighting modes to satisfy a wide variety of different lighting applications. In
addition to allowing users to easily set the power @ 20%, 40%, 60% or 100%, it also
changes the lighting time from 1 hour to 12 hours.
It comes with 4 different lighting modes (A, B, C and D) built-in. Users can set their own
lighting mode, and press the button of Time zone to set the time. This remote also
supports lighting during the day time while the luminaire is being charged by solar panel.
It even works for indoor lighting perfectly.
- Amount of Light output depends on the percentage selection.
- By default the light will operate for 12 Hours.
* Helpful Hint.
Select a Time Setting (e.g. 4H) within 5 seconds
to modify the default operating time.
- Light Duration based on selection.
* Helpful Hint.
- Select 20% then 4H. Light will operate at 20% for 4 Hours.
- Select C then 8H. Light will operate at 50% for 8 Hours + 100% if sensor triggered.
- Select D then 3H. Operate at 100% for 1.5 Hours, 50% for 1.5 Hours + 100% with sensor.
5-6-7-8-9 are similar time function as 1-2-3-4....
- By default the light will operate for 12 Hours.
* Helpful Hint. Select a Time Setting (e.g. 9H)
within 5 seconds to modify the default
operating time.
5
REDA SOLAR User Manual
Subject to change without notice.
Advertisement
