Advertisement
REDA SOLAR User Manual
Fix the two metal clips into position and attach to surface. It is recommended that each
clip is positioned approximately 20cm from each end of the REDA SOLAR.
Caution: Ensure correct anchor sleeves are used for surface material.
Please see package contents before installation.
Insert Tensioning Bolt and attach the
REDA SOLAR to the metal clips
Connect the MC4 Connectors to the Solar panel.
Note : A matching pair of MC4 connectors
are included in the contents of this
package. If the Solar Panel does
NOT have an identical pair of MC4 connectors,
replace them with the ones provided to
guarantee a weather tight connection.
LED IT COMPANY LIMITED
Room A, 21/F, Gaylord Commercial building,
114 -118 Lochkart Road, Wanchai, Hong Kong
Contact : sales@leditinternational.com
20CM
Using a screw driver, secure each clip onto the
REDA SOLAR with the Tensioning bolt.
Note : This is only to secure the REDA SOLAR, so it cannot
be removed - Do not stress it tightening it too much.
Power ON the REDA SOLAR. A RED signal light
can be seen at the sensor end of the REDA SOLAR.
Program the light to best suit your installation.
Please refer to setup guide of manual properly.
Light will work at 50% power when nobody
there and 100% power for 60 seconds when
sensor is triggered by someone passing by.
1
REDA SOLAR User Manual
Subject to change without notice.
2
Advertisement
