Sony BKSI-2440 Series Installation Manual page 13

Procedures
1. Turn the SIU-80A/80 power off and unplug the power
cord from the outlet, and remove the blank panel at the
rear. (Refer to the Installation Manual supplied with
the SIU-80A or the SIU-80.)
2. Set the switches and connectors on the board (BKSI-
2042 only).
3. Attach the model label supplied with the connector
panel in the chassis near the slot to install the board.
n
After the connector panel is inserted into a slot, the
slot label cannot be seen.
4. Insert the connector panel to the matching slot and
secure the panel by the two screws which installed the
blank panel to the SIU-80A/80.
Model label
BKSI-2440
SIU-80A/80
BVTT 3 x 6
Blank panel
SIU-80A/80
Connector panel
BVTT
3 x 6
5. When remove the connector panel, turn the power off
and remove the power cord plug from the receptacle,
and then remove the panel in the reverse order of steps
1 through 4.
n
To remove the connector panel, pull the right and left
handles on the connector panel until the connection
with the mother board is sufficiently loose, then pull
out the connector panel gently.
Information for inserting slot
BKSI-2441
Insert this connector panel into the No.1 slot.
Use this panel a pair with the root controller BKSI-2440
(plug-in board) which is inserted into the No.1 slot in the
front of SIU-80A/80.
n
When Server Management System has the multiple SIU-
80A/80 units installed the iDC boards, the root controller
BKSI-2440 is installed in the only one of SIU-80A/80
units.
BKSI-2042/2043/2044
These connector panels are inserted into any slot No.2 to
No.8 in the rear of SIU-80A/80.
Use each panel a pair with device controller BKSI-2440
which is inserted in the front slot of SIU-80A/80.
1-5 (E)