Using The Heki 2 De Luxe - Dometic Heki 2 de Luxe Installation And Operating Manual

Heki 2 deluxe
➤ Check that the roller blinds can move freely.
If they do not, then loosen the screws slightly.
See fig. a
➤ Make sure the lights are fitted securely.
➤ Connect the power supply line to an available socket.
See fig. b
➤ Clip the ventilation grille (1) onto the long sides.
It needs to click in.
➤ Clip the light covers (2) onto the short sides.
They need to click in.
If you have not connected the lamps, you can fit the ventilation grille supplied
instead of the lamp covers:
➤ Remove the protective film from both sides of the acrylic glass.
NOTE
I
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
➤ After installing, check the roof light works properly.
➤ If necessary, enter the new vehicle height and weight in the vehicle
documents.
8

Using the Heki 2 de Luxe

8.1 Opening in the tilting position (fig. c)
➤ Press the latches on both rotary bolts and turn them 90° (A).
➤ Hold the bracket in the middle and move it out of the original position (B).
➤ Tilt it downwards.
➤ Push the glass dome upwards (C).
Opening the glass dome is supported by the two gas springs after
approx. 150 mm.
EN
Using the Heki 2 de Luxe
19