Troubleshooting - Klarstein VariCook Domino Manual

TROUBLESHOOTING

Problem Possible Cause
The hob is not There is no power to the
working. appliance.
The timer has elapsed.
There is overflowing liquid on
the control panel. The automatic
overflow protection ensures that
the hob switches off.
The function The buttons are locked because
buttons do not the child lock is activated. "Lo"
react or are appears in the timer display.
very difficult to
A thin film of water or a wet
operate.
cloth is on the control panel
and the automatic overflow
protection has been activated.
You are using the fingertips
instead of the ball of your
finger.
After cooking The automatic safety function
there is "H" residual heat warning has been
shown on activated.
display.
After switching The induction hob is completely
off, the fan of cooled down by the continued
the induction operation of the fan.
hob remains
working for a
while.
Possible Solution
There may be a power failure.
If not, make sure the hob is
plugged in and turned on.
Check whether a fuse is turned
on or broken. If the problem
persists, contact a qualified
technician.
The set cooking time has been
reached and the appliance has
switched off automatically.
Clean the control panel (see
section "Cleaning and care").
Deactivate the child lock (see
"Deactivate the child lock" in
the "Other Functions" section).
Check if the buttons are dry
and wipe them dry if necessary.
Use the ball of your finger.
That is normal. The hob is
equipped with safety functions
to warn against residual heat.
It remains on until the surface is
cool enough to touch.
That is normal. The "run-on"
of the fan is not a fault, but the
necessary cooling function of
the hob.
EN
55