Klarstein VariCook Domino Manual page 42

EN
42
Set the heating level as follows:
Model with Touch control (figure right):
Set heat setting by touching the "+" or "-" button. If
you touch and hold either of the two buttons, the value
will adjust down or up rapidly, from 0 to 9 in circle.
4
Models with Slider Touch control (figure below):
Adjust heat setting by sliding the slider control.
Notes on Use
• After you connected the appliance to electricity, when power on, the buzzer
sounds briefly. All displays light up for 1 second and then go out again.
• When the hob is in standby mode, if there is no practice within 1 minute, the electric
hob will auto turn off, with buzzer beeps once.
Note: To turn on the hob, touch the ON/OFF button and hold on for about
3 seconds. To turn it off, you just need to touch the ON/OFF button briefly.
• The power level can be adjusted from 0 to 9, default setting is level 5.
• The heat setting indicator of the selected zone is flashing when adjusting. After
adjusting, the number is flashing for 5 seconds then stops flashing, the setting is now
confirmed.
To turn off hob
Touch the corresponding cooking zone button on the
control panel and use either the "+" or "-" button or the
1 touch slider, depending on the model, to set the heat
level to 0. The cooking zone is now switched off and
the display shows „-" in this case.
You can also turn the whole hob off by touching the
2
ON/OFF button.
Note: The cooling fan of induction hob will remain on for about 1 minute after the
hob is turned off.
Note: If there is power cut off during cooking, all setting will be cancelled.