Table of Contents
Advertisement
Available languages
Available languages
How to connect Outdoorcam camera to your TV or VCR
At the end of your Outdoorcam camera cable you will find two colored plugs:
Step 1:
•Yellow (Video RCA)
•Black (DC Power)
Plug the
Step 2:
yellow
or VCR).
Connect the
Step 3:
of the
power adaptor
Plug the
Step 4:
power adaptor
If you have an
Step 5:
your
to view the camera. To connect the Outdoorcam camera to your
TV
turn the
VCR
use to view a tape or movie on your
remote that is marked with this symbol
The Outdoorcam will automatically turn on the Infra-Red LEDs when available light is too low to
Note:
support a clear picture.
Please read the
Note:
A/V inputs.
Mounting the camera on your wall or ceiling
Once you have chosen the best position for the camera, switch the power to the
1.
camera off, and unplug the power lead from the camera.
When mounting the Outdoorcam camera to your ceiling or wall, please ensure that
2.
you rotate the camera so that at the top of the camera lens is 'up', otherwise you will
find that your pictures are displayed upside down. (see diagram)
Hold the camera base in the position you wish to fix it, and mark the holes with an
3.
appropriate pen or pencil. Once this is done, remove the stand and drill a hole with
the appropriate drill bit for the material you are mounting your camera to and the
screws or fasteners you are using.
Run the camera cable back to the TV/VCR, any holes that you drill need to be at least
4.
9
/ " (14mm) in diameter to allow the connectors to pass through.
16
Reconnect the power lead to the camera and switch the camera power back on.
5.
6. Position the camera and firmly lock the stand into place. Do not over tighten or
forcefully adjust the camera once it has been correctly positioned.
RCA plug (1) into the
plug (3) at the end of your Outdoorcam camera into the
black
(4).
(5) into the mains power point in your wall.
with RCA sockets you will need to switch the
A/V TV
to the
selection and turn your
A/V Input
for your
instructions
input (2) (usually located at the back of your TV
"Video In"
TV
. This channel may be activated by a button on your
VCR
, or
or
or possibly
L
L2
1
or
for more information on using their
VCR
TV
plug at the end
black
to the
TV
AV
, you will need to
VCR
onto the channel you would normally
or
.
AV
AV2
1
channel on
3
Advertisement
Table of Contents
