Working Instructions - Kaba Mauer Code-Combi B Operational Instructions

GB

1 Working instructions

Important points
• Before putting the lock into operation, please read the instructions carefully.
• Carry out the programming sequences with the lock and the safe opened.
• Every correct entry keyed in and recognised by the lock is confi rmed by an acoustic signal.
These confi rmation signals are not taken into consideration in the following notes.
• You have 20 seconds for each entry keyed in. If you have not pressed a key within this 20
second period, the electronic system will close down automatically. Operations not fully
completed have to be re-started.
• Code entries can be interrupted by pressing the P button.
• The lock is set at the works code 1 2 3 4 5 6 when supplied. Alter this immediately to your
own personal code for security reasons. Do not use any personal or other similarly well
known data (for example birthdays) when selecting this code.
• The lock is provided with a device to monitor any manipulation. This is also activated
during servicing work on the input unit and also when the battery compartment integrated
in the input unit is opened. The manipulation signal then has to be cancelled later.
• Should the battery not be accessible from the outside, the lock has to be opened with the
override key to replace faulty or discharged batteries.
• The override key should be kept in a safe place but not in the safe itself.
General instructions
• The lock is designed for use from +10° C to 50° C.
• The lock should be cleaned using a damp cloth only (do not use any aggressive cleaning
agents).
• The lock must not be lubricated.
• Never open the lock casing. Should dismantling be required on the fi ttings, please carry
this out in strict accordance with the operational instructions provided. Failure to comply
with this will endanger the correct functioning of the lock and result in your losing warranty
entitlements.
Page 22 82132 Code-Combi B Kaba Mauer GmbH