General: Slat Joints - Hella AF 80 K Technical Documentation Manual

Gear Blind OS 58/56

General: Slat Joints

Types: AF 50, AF 80, AF 100
22 Subject to technical modifi cations - Date 06/2006
The slats are kept evenly
apart using a ladder cord.
With blind types AF 80
th
and AF 100, every 4 slat
is equipped with plastic
slat clips, thereby pre-
venting the lifting tape
from getting too worn
and the ladder cord from
sliding off to the side.
With a stable wire tension
system or wire tension, no
slat tensioning wire clips
are possible.
For a surcharge, every slat
can be equipped with a
slat clip, if required (note:
higher slat packages must
be considered).
AF 50 is supplied without
plastic slat clips. The lad-
der cord is then protected
underneath the slats by
punched parts that match
the colour of the slat.
If required, for a surcharge
the ladder cord can be
joined non-positively with
each slat (double Omega-
punching). Fixed in this
way, the blind is centred
and becomes very stable.
Warning: the closing pro-
cess, however, changes
for the worse.