Electrolux EWF7525DGWA User Manual page 9

NOTE
If you Do not wish to use the soak
water to wash cloth, please follow
the steps below:
1. Press Start/Pause to pause the
washing machine. Then press
On/Off to turn off the machine.
Press On/Off again to start the
2.
machine, add detergent, and
select the program of your
choice. Press Start/Pause again
to start the selected program.
The machine will detect and
drain the water in the washing
drum out automatically and fill in
water once again to be used for
washing.
NOTE
Any temperature may be
selected, but "Cold" water is
recommended with this cycle as
hotter water may set some stains.
Use the amount of detergent
recommended for a normal
wash cycle. If desired, use a
bleach or a soaking agent safe
for the fabric, by pouring it into
the detergent compartment.
Start/Pause
10
Add Clothes
This touchpad has 2 functions:
●
Start/Pause (
After you have selected the
desired program and options,
press this touchpad to start the
machine. The Start/Pause pilot
light will stop flashing and remain
lit until the water level is above
the bottom edge of the door then
pilot light goes OFF. If you have
selected a "Delay End" option,
the countdown will begin and will
be shown in the display.
and
Touchpad
):
To interrupt a program which is
running, press this touchpad to
pause the machine, the Start/Pause
pilot light flashes.
To restart the program from the
point at which it was interrupted,
press this touchpad again, the
Start/Pause pilot light will stop
flashing.
●
Add Clothes (
You can only add clothes if
"Start/Pause" pilot light is lit.
While running a program, you
may add clothes by:
-
Pressing the "Start/Pause"
touchpad to pause the program.
-
Wait for the machine to come
to a complete stop before
opening the door.
-
Add clothing and close the
door.
-
Resume the program by
pressing "Start/Pause"
touchpad again.
11 Buzzer Sounds
The buzzer sounds operate when:
The program is completed.
The appliance has a malfunction.
If you want to disable the buzzer
sound (except for event of
appliance has a malfunction),
"Easy Iron" and "Soak" touchpads
at the same time about 6 seconds,
and listen for "BEEP, BEEP".
To return to default configuration
press these 2 touchpads at the
same time for 6 seconds, and listen
for "BEEPS".
ENGLISH 9
):
press