Electrolux EWF7525DGWA User Manual page 27

Malfunction Possible cause
The transit bolts and packing
have not been removed.
The support feet have not
been adjusted.
The machine
The laundry is not evenly
vibrates or is
distributed in the drum.
noisy:
There is very little laundry in
the drum.
Unstable floors eg.
wooden floors.
Detergent over dose.
Cycle time
Machine unbalance.
longer than
displayed:
The electronic unbalance
detection device has cut in
because the laundry is not
evenly distributed in the drum.
The laundry is redistributed by
reverse rotation of the drum.
Spinning starts
This may happen several
late or the
times before the unbalance
machine does
disappears and normal
not spin:
spinning can resume. If, after
10 minutes, the laundry is still
not evenly distributed in the
drum, the machine will not
spin. In this case, redistribute
the load manually and select
the spin program.
Machine not installed
properly.
The machine
Transit bolts or packaging
makes an
not removed.
unusual noise:
The load may be too small.
Solution
Check the correct installation of
the appliance.
Check the correct levelling of
the appliance.
Pause the machine and
redistribute laundry manually.
Load more laundry.
Refer to relevant paragraph
in "Positioning" section.
Reduce the detergent
quantity or use another one.
Redistribute laundry manually
in the drum and start the spin
phase again. Refer to relevant
paragraph in "Positioning"
section.
Pause the machine and
redistribute laundry manually.
Make sure the levelling of
the appliance is correct.
Refer to 'Installation'.
Make sure that the packaging
and/or the transit bolts are
removed. Refer to "Installation".
Add more laundry in the
drum.
ENGLISH 27