Advertisement
Installation
1. Choose a suitable flat working surface for the machine, with enough
room around the machine to work. Do not connect the power supply
until all other steps have been completed.
2. Remove the Eco Clean machine from the protective bag and peel off
the tape on the front of the lid. Then remove the polystyrene block
from between the lid and the turntable.
3. Remove the cap from the cleaning fluid bottle and replace it with the
special cap with tubing connected to the machine. Check the tubing
reaches the bottom of the bottle. The bottle should now be placed in
the tray area at the back of the machine.
4. With the AC/DC Power Supply still disconnected.
Prime the Cleaning Fluid tubes and Pump by first
placing the priming assist foam over the slot in
the back. Then repeatedly open and close the
cover until cleaning fluid is sprayed from the
nozzle onto the turntable. Then wipe the
turntable to remove any excess cleaning fluid
and remove the priming assist foam tool.
5. The key card is already installed in the card slot on the side of the
machine so there is no need to touch it at this stage. The card will
activate the machine for 1000 disc cleans.
6. The Cleaning Roller is already installed in the machine so there is no
need to touch it at this stage. The Cleaning Roller is ready to be used
for 1000 disc cleans.
7. Finally unwrap the AC/DC Power Supply and the Cable for the AC/DC
Power Supply and connect it to the DC input on the side of the ma-
chine. Then plug into the mains and switch on.
8. The LED should be green indicating that your Eco Clean is now ready
to use!
©Total Disc Repair
|
www.totaldiscrepair.co.uk
|
Technical Support: 0800 412 5424 - support@totaldiscrepair.co.uk
Operation
1. First place the disc to be cleaned on the turntable with the shiny side
up and the label side down.
2. To operate the machine just close the lid and the Eco Clean begins
cycle automatically, keep holding the lid down.
3. Initially the LED turns red then after just 2 or 3 seconds the led will
turn orange indicating the cleaning process is finished.
4. Immediately release the lid to remove a completely clean and dry disc.
LED status indicator
With the machine idle:
Continuously Green
Flashing Red and Amber
Continuously Amber
Flashing Green
Flashing Amber
Flashing Red
Flashing Red, Amber and Green
With the machine running:
Continuously Red
Continuously Amber
Flashing Red
|
Sales: 01202 489 500 - sales@totaldiscrepair.co.uk
=
Ready for cleaning
=
Invalid key card inserted
=
No key card inserted
=
3001 - 3000 cleans remaining
=
1001 - 2000 cleans remaining
=
1 - 1000 cleans remaining
=
No cleans remaining
=
Cleaning in progress
=
Cleaning complete
=
Motor overloaded
Advertisement
