Econ sens+ User Information

Table of Contents

Download this manual

Introduction

We are pleased that you have purchased this product from econ solutions and are confi-

dent that you have made the right decision in choosing this product.

Your econ sens+ / econ sens+ pro from econ solutions consists of mounted and tested

mechanical and electronic components. For operation in accordance with regulations

please pay heed to the technical data and ensure correct installation

All products undergo comprehensive safety and performance testing before they are

shipped. Nevertheless, you must perform at least the following:



Please ensure that the device has survived transport without damage.



Before you connect the device and switch it on, you must check the operating voltage

on the basis of the relevant technical data.

We assume no responsibility for parts that have been destroyed as a result of in-

correct operating voltages!

econ sens+

User information – Please read first!

page 1 of 4

Article-No.: 222421 // Index: 0.6

Table of Contents

Do you have a question about the sens+ and is the answer not in the manual?

Page 1 User information – Please read first! Introduction We are pleased that you have purchased this product from econ solutions and are confi- dent that you have made the right decision in choosing this product. Your econ sens+ / econ sens+ pro from econ solutions consists of mounted and tested mechanical and electronic components.
Page 2  User information Defects: If the econ sens+ / econ sens+ pro does not start up properly once the operating voltage is applied and if the “Log” LED does not light up red, please re-disconnect the device from the supply voltage. If this does not remedy the defect you can find more information and sup- port at www.econ-solutions.de...
Page 3 Rogowski coils please ensure that they are mounted in the correct direction, as depicted on the coils themselves. Connect the econ sens+ / econ sens+ pro to your PC via the network cable. Enter the IP- address 192.168.0.1 in your web browser to access the econ sens+ / econ sens+ pro web interface.
Page 4: Warranty Conditions
Electronic Equipment Act (ElektroG). Products that are no longer used can be returned to us, where they will be disposed of in a professional manner. For further information please visit our homepage www.econ-solutions.de or contact us by e-mail (econ-sens@econ-solutions.de) Karlsruhe, October 2013. This documentation was created econ solutions GmbH and checked with care;...

Sens+ pro