Recommended Amplifier - Bose RoomMatch Utility RMU108 Installation And Safety Manuallines

Installation
Mounting the RMU108 Loudspeaker on a Speaker Stand
The RMU108 is the only RMU loudspeaker that has two M8 threaded inserts on one end for mounting an
industry-standard stand-mount adapter. This allows you to vertically mount the RMU108 on a speaker
stand, such as the Bose SS10 model. Other stands have not been tested and may create a tipping hazard.
1. Using the T3 square drive (included), remove the two plastic inserts on the end panel of the RMU108
loudspeaker.
Note: You may need to remove the center insert to allow the adapter to fit properly.
2.
Attach the bracket to the loudspeaker using M8 screws.
3. Mount the loudspeaker on the stand and tighten the bracket.
Figure 12. RMU108 speaker stand adapter threaded inserts
Stand adapter inserts

Recommended Amplifier

Selecting the proper amplifier size for a given loudspeaker requires analysis of the transducer long-term (or RMS) power rating, dynamic
range of the input-source material (crest factor), desired sound pressure levels, and other factors. As a general guideline, the following
table provides recommended power amplifier ranges for each RoomMatch
RoomMatch Utility Model
RMU208
RMU206
RMU108
RMU105
CAUTION: Failure to follow these guidelines may result in damage to the loudspeaker.
The Bose PowerMatch configurable power amplifiers offer optimal amplification and DSP for RoomMatch Utility loudspeakers.
® ®
Please refer to the specifications listed on the pro.bose.com website for PowerMatch amplifiers and compare with the table above to
determine which PowerMatch model is best for your particular RoomMatch Utility system design.
14 English
Nominal Impedance Required Channels
8 ohms
8 ohms
8 ohms
8 ohms
Utility model:
®
Amp Power Rating
1 300 – 1200 W
1 250 – 1000 W
1 200 – 800 W
1 100 – 400 W
pro.Bose.com
Installation and Safety Guidelines