Control Rod Adjustment (Except For Rxw10Gtw) - Yamaha RX10RTW Supplementary Service Manual

CONTROL ROD ADJUSTMENT (Except for RXW10GTW)

CONTROL ROD ADJUSTMENT
(Except for RXW10GTW)
Control rod stroke
CAUTION:
Make sure the adjusting bolt ends are set at
the same position on each side.
1. Loosen the lock nut
2. Turn the adjusting nut
the control rod stroke.
Adjusting
1
position
Increase
Effect weight
transfer
Standard
WARNING
Never adjust the control rods beyond the
maximum range indicated on the rods with
red paint .
3. While holding the adjusting bolt securely,
tighten the locknut
Locknut:
25 Nm (2.5 m•kg, 18 ft•lb)
Damping (For RXW10GTW)
1. Adjust
• Damping
Adjustment step:
• Press the mode switch
• Make sure to switch the multi-function meter
to the electric suspension adjustment indica-
tor .
• To harden the suspension, push the electric
suspension/grip warmer adjustment switch
located at the left handlebar switch
"HI" side, or push it to the "LO" side to soften
and adjust.
22
INSP
ADJ
.
in or out to adjust
2 3
Decrease
← →
pitching
2
.
to the