Technical Data; Operation - Bosch BCS220 Original Operating Instructions

English – 2

Technical data

Charger
Product code
Rated voltage
Frequency
Battery charging voltage
Charging current (max.)
Charging time
– PowerPack 300, approx.
– PowerPack 400, approx.
– PowerPack 500, approx.
Operating temperature
Storage temperature
Weight, approx.
Protection rating
The charging current is limited to 4A for the PowerPack
A)
300 and for Classic + Line batteries.
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.

Operation

Start-up
Connecting the charger to the mains (see figure A)
 Pay attention to the mains voltage. The voltage of
the power source must match the voltage specified on
the rating plate of the charger. Chargers marked 230 V
can also be operated at 220 V.
Plug the device connector (3) of the power cable into
the device socket (2) on the charger.
Connect the power cable (country-specific) to the mains.
Charging the removed battery (see figure B)
Switch the battery off and remove it from its holder on
the eBike. When doing so, read and observe the
operating instructions of the battery.
battery is placed on clean surfaces only. Avoid getting
dirt, e.g. sand or soil, in the charging socket and contacts
in particular.
Plug the charging connector (5) of the charger into the
socket (6) on the battery.
Charging the battery on the bike (see figures C and D)
Switch the battery off. Clean the cover of the charging
socket (7). Avoid getting dirt, e.g. sand or soil, in the
0 275 007 XCX | (24.04.2018)
Standard Charger
(36–4/230)
BCS220
207...264
~
Hz 47...63
=
A
hrs
hrs
hrs
°C
°C –10 ...+50
kg
charging socket and contacts in particular. Lift the cover
of the charging socket (7) and plug the charging
connector (5) into the charging socket (6).

Charging process for two batteries
If two batteries are fitted to an eBike, both batteries can
be charged using the uncovered connection. To begin
with, both batteries are charged one after the other
until they reach approx. 80–90 % capacity, then they are
both charged at the same time until full (the LED flashes
Ensure the

on both batteries).
When the bike is in operation, power is drawn from both
batteries on an alternating basis.
If you take the batteries out of the holders, you can
charge each one individually.
Charging process
Compact Charger
(36–2/100-230)
BCS230
90...264
47...63
36
4
2,5
3,5
4,5
...+40
–10 ...+50
0,8
IP 40
Charge the battery only in accordance with all
safety instructions. If this is not possible, remove the
battery from the holder and charge it in a more
suitable location.
When doing so, read and observe the operating
instructions of the battery.
Fast Charger
(36–6/230)
BCS250
207...264
47...63
36
2
5
6,5
7,5
...+40
–10 ...+50
0,6
IP 40
Bosch eBike Systems
36
A)
2
2,5
3
...+40
1,0
IP 40