MC2 Audio E Series Instruction Manual page 15

TECHNICAL SPECIFICATION
Output power (Watts RMS)
per channel
8 ohms @ 1kHz
4 ohms @ 1kHz
2 ohms @ 1kHz
Mono Bridged
8 ohms @ 1kHz
4 ohms @ 1kHz
THD @ rated power
4 ohms 1 kHz
20Hz-20 kHz
Input CMRR
Hum & Noise
Gain (selectable)
Sensitivity for
rated output, 4 ohms
Damping Factor 1 kHz, 8 ohms
Frequency response
Input impedance (actively balanced)
Dimensions (mm) - 2U
Weight
Power requirement
Power requirements
The E100 can be supplied for nominal mains voltage of 115V or 230V.
An internal link can be set to either 100V or 120V for the 115V version and 220V or 240V for the 230V
version. Normally these are set to 120V and 240V respectively.
This amplifier will only operate to its very high specification if it is installed and operated
as described in this manual.
1400
2800
3700
5300
17400
<0.08%
<0.15%
>80dB
-110dBA
+26dB/+32dB/+36dB
+16dBu (4.9v)/+10dBu(2.5v)/+6dBu(1.5v)
>400
20Hz-20kHz - +0/-0.5dB
20k ohms
8x482x428
11.8kgs
230 VAC @ 20 amps max
115 VAC @ 40 amps max
15