Conventions; Pictograms - General Safety Notes - Scholl 22001/MM Instructions For Use Manual

Heat lamps solid, rail design
Table of Contents

Advertisement

GBA B 0020 2 E
1
C
ONVENTIONS
1.1
P
– G
ICTOGRAMS
Be sure to observe these Instructions for Use as well as the safety notes to prevent
injuries or damage to health or property. Do not alter or modify this appliance.
Never use a defective appliance. If you suspect the unit of being faulty or discover
an unusual noise or smell, turn off the power switch and pull the plug out of the
socket-outlet, or otherwise disconnect the appliance from the mains and de-
energize it (i.e., ensure that it no longer carries any voltage). Do not use this appli-
ance when its power cord is damaged.
Failure to observe this warning may result in a fire hazard or electrical shock!
Maintenance and repair work must be carried out only by qualified professionals
using original spare parts and accessories. Do not attempt to carry out repairs on
this appliance yourself!
Connect this appliance to suitably earthed mains outlets only. Ensure that your
mains power supply conforms to the data stated on the nameplate of the appliance.
Failure to observe this warning may result in a fire hazard or electrical shock!
This appliance is not intended to be used by persons (including children) of limited
physical, sensory or intellectual abilities, or lacking in experience and/or knowledge,
unless they are supervised by a person responsible for safety who instructs them in
the use of the device. Children should be supervised to ensure they will not play
with this appliance.
Do not allow this appliance to operate unattended. Ensure that its power switch is
set to „0" before inserting the plug into an electrical socket-outlet. Avoid starting
the unit unintentionally. Connecting the unit to the mains with its power switch set
to ON may cause accidents.
Protect this appliance from moisture (water spray, rain). Do not immerse the appli-
ance in water or other fluids and do not place it in a dishwasher. Any penetration of
water into the unit will increase the risk of an electrical shock.
BA
Last revised 12-2017
ENERAL SAFETY NOTES
Page 5 of 30
Dezember 22, 2017
Rev. 2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents