Stroller Operation; Unfolding And Folding - BOB Gear Revolution Flex Duallie User Manual

Check the front wheel before
each use of the stroller to
ensure it is properly secured�
Failure to secure the front
wheel can cause the wheel to
vibrate, wobble, or become
detached from the stroller�
FALL HAZARD - Wheel can
detach and cause tip over� Pull
on the wheel to assure it is
securely attached�
Front Wheel Removal
1� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 9.
2� Remove Through-Axle
Hold the nut in place and use
the hex wrench to loosen the
through-axle. Then remove the
through-axle from the front wheel
and fork.
3� Remove Front Wheel
Raise the front wheel a few inches
off the ground and pull wheel
down to remove.
IMPORTANT: Secure and safely
store all small parts.
REVOLUTION FLEX DUALLIE User Guide

Stroller Operation

Unfolding and Folding

Unfolding the Stroller
1� Lift Red Frame Release Handle
Keep tires on ground as stroller
swing arm begins to swing open.
NOTE: Stroller swing arm will
swing open and snap into an
open and locked position.
2� Rotate Handlebar
Lift handlebar up and back until
it snaps into locked and upright
position.
7