The "Athos" CA-1802 and CA-1803BT car alarms
Thank you very much for buying our CA-1802/CA-1803BT car alarm. Now you will always be able to
find where you left your car.
Controlling the car alarm
The alarm will be armed when the car is locked remotely by the original remote control and
disarmed when the car is unlocked remotely. The locking must always be followed by
confirmation from the turn lights.
If the car is unlocked directly by its door key (no confirmation from the turn lights) then an
alarm will be triggered. This is a protection against damaging car locks mechanically. To stop
the alarm it is necessary to unlock it remotely by the original remote control.
Buttons present on the key fob can be used for additional functions, e.g. remote operating of the gate or
hands free calling. Please ask your installer for detailed information.
Remote control via a mobile phone
You can operate the car alarm by your mobile phone. The car alarm will send alarm messages to
the phone and call after an alarm has been triggered. You can send SMS instructions via an
authorized mobile phone to the car alarm's phone number (see table below).
In addition, the car alarm allows you remote control by
You only have to dial the car alarm's phone number (while the ignition key is turned off). The car
alarm will not answer the incoming call, but when it recognizes your number, it will change status
(to Arm or Disarm). Such remote control is free of charge since the phone is not answered.
Status changes can be confirmed by SMS messages.
If you operate the car alarm by SMS instructions, you only will arm or disarm the car.
No locking or unlocking will occur.
In the case that you do not remember particular SMS instruction(s) you can ask for
help by sending a HELP instruction.
Default
AM
DM
IMO
UNIMO
STATUS
GPS
LOCATOR
HELP
CREDIT
AUX
parameter
UC xx...x
Only basic ASCII can be used in the SMS instruction texts.
Ask the installer to edit the SMS commands for you.
1
Only applicable if supported by the GSM provider.
2
A qualified technician is required for setting up this function.
CA-1803BT, CA-1802 User manual – Mode 2
MODE 2
SMS instruction texts
Your text
Arm the car (no locking)
Disarm the car (no unlocking)
STOP (immobilize) the car (after turning the ignition key off)
Unblock (mobilize) the car
Car alarm will reply with status information, e.g.
reports: Time: 27.01.04 13:04, Status: Armed, Unblocked, Ignition off"
To obtain the car location via GPS
To obtain the car location from the GSM provider
Car alarm will reply with a brief list of SMS instructions.
To obtain the balance of a prepaid SIM card if used
To operate appliances
To change the user code (do this during installation).
xxx...x is the new user code, 4 to 8 characters (A –Z & 0
– 9). The factory default user code is USER
dialing-in from an authorized phone
2
Description
- 1 -
Jablotron s.r.o.
2
.
„car
.
1,2
2
MHF57000