jablotron Athos CA-1202 User Manual

Your installer's contact details:
CA-1202 user manual – Mode 3
Pod Skalkou 33
466 01 Jablonec nad Nisou
Tel.: 483 559 911
fax: 483 559 993
Internet: www.jablotron.cz
- 4 / 4 – MHF53501
The "Athos" CA-1202 GSM pager
MODE 3
Thank you very much for buying our CA-1202
able to find where you left your car.
1. Alarm
warning SMS messages will be sent to all
In the case of activation,
phones (TEL1 to TEL4) and these phones will also be called with a
1
siren sound .
2. Remote control by SMS instructions
SMS instructions sent from an authorized phone (TEL1 to TEL4)
can operate the alarm remotely. Factory default instruction texts
are shown in the following table. If an SMS is sent from an
unauthorized phone a valid user code must be entered before
the instruction (e.g. USER IMO).
SMS instruction texts
Default Your text
IMO
UNIMO
STATUS
LOCATOR
HELP
CREDIT
UC xx...x
Only basic ASCII can be used in the SMS instruction texts.
Ask the installer to edit the SMS commands for you.
After the HELP command, the GSM pager will reply with the factory default SMS instructions.
The instructions that were modified will not be in the reply.
1
If it is activated, then in the case of an alarm all calls are automatically answered
(it is possible to listen and speak to the car remotely).
CA-1202 user manual – Mode 3
GSM pager
. Now you will always be
Jablotron Ltd.
Description
STOP (immobilize) the car (after turning
the ignition key off)
Unblock (mobilize) the car
GSM pager will reply with status
information, e.g.
„car reports: Time: 27.01.04
13:04, Status: Armed, Unblocked, Ignition off".
To obtain the car location from the GSM
2
provider.
The GSM pager will reply with a brief list of
SMS instructions.
To obtain the balance of a prepaid SIM
2
card if used.
To change the user code. uuuu is the new
user code, up to 8 characters (A –Z & 0 –
9). The factory default user code is USER
- 1 / 4 – MHF53501