The "Athos" CA-1802 and CA-1803BT GSM pagers
Thank you very much for buying our CA-1802/CA-1803BT GSM pager. Now you will always be able
to find where you left your car.
Alarm
When an alarm is triggered, warning SMS messages will be sent to all phones (TEL1 to TEL4)
and these phones will also be called with a siren sound
Remote control by SMS instructions
You can operate the car alarm remotely via SMS instructions sent from an authorized phone
(TEL1 to TEL4). Factory default instruction texts are shown in the following table. If an SMS is
sent from an unauthorized phone a valid user code must be entered before the instruction (e.g.
USER IMO).
In the case that you do not remember particular SMS instruction(s) you can
ask for help by sending a HELP instruction.
Remote control from an unauthorized phones
You can operate the car alarm via SMS instructions sent from arbitrary mobile phone, even an
unauthorized one. In that case, the user code must be inserted at the start of every SMS
instruction, separated by a space. Example: MYCODE STATUS. The factory default value of
user code is USER. The code can be modified by an instruction. See the table above or ask a
service center for help.
Default
IMO
UNIMO
STATUS
GPS
LOCATOR
HELP
CREDIT
AUX
parameter
UC xx...x
Only basic ASCII can be used in the SMS instruction texts.
Ask the installer to edit the SMS commands for you.
1
If a call is activated after an alarm has been triggered and you answer the call, you will hear a siren sound
from the receiver. If a hands-free set is installed, listening to the car will be triggered.
2
CA-1803BT only
3
Only applicable if supported by the GSM provider.
4
A qualified technician is required for setting up this function.
CA-1803BT, CA-1802 User manual – mode 3
SMS instruction texts
Your text
STOP (immobilize) the vehicle (if installed)
Unblock (mobilize) the vehicle (if installed)
GSM pager will reply with status information
To obtain vehicle's location via GPS
To obtain vehicle's location from the GSM provider
GSM pager will reply with a brief list of SMS
instructions.
To obtain the balance of a prepaid SIM card if used
To operate appliances
To change the user code (do this after installation).
- 1 -
1
.
xxx...x is the new user code, 4 to 8 characters (A –Z
& 0 – 9). The factory default user code is USER
Jablotron s.r.o.
Description
2
3,4
4
MHF57100