jablotron Athos CA-1802 User Manual page 2

You can operate the car alarm via SMS instructions sent from arbitrary mobile phone, even an
unauthorized one. In that case, the user code must be inserted at the start of every SMS
instruction, separated by a space. Example: MYCODE STATUS. The factory default value of
user code is USER. The code can be modified by an instruction. See the table above or ask a
service center for help.
The car alarm informs you about its status by
siren chirps. The chirps for arming, disarming
and arming with the triggered input (e.g. an
open door indication) are optional, you can
disable it. The other signals, owing to their
importance, cannot be disabled.
Warning! If the GSM network is not
available while the car alarm is being
armed, the car alarm will respond with 6
beeps to indicate that it is not be able to
send any messages nor call in the case of
an alarm.
The LED indicator is used to
show the status of the alarm.
Warning!
indicator
fast after the ignition is
switched off, it will not be
able to send any messages
nor call in the case of an
alarm.
The car alarm allows you to enroll up to 8 wireless detectors, as for instance glass break
detectors or motion detectors, for protecting the area inside the car or even outside the car up
to a distance of about 40 meters. After arming the car alarm, an exit delay of 20 seconds is
provided to all enrolled detectors (the detectors are ignored during this delay). A 20 second
entrance delay after triggering a detector is provided by the detectors that are switched to
delay mode. In the case of an alarm, the siren will sound for 30 seconds. The detectors can be
enrolled as either internal or external.
Detectors are supplied by a battery with a minimum lifetime of 1 year. Voltage-drop is
responded by the system via an SMS.
CA-1803BT, CA-1802 User manual – Mode 2
Remote control from unauthorized phones
Example of arming via SMS sent from an unauthorized phone: USER AM
If the LED
starts flashing
Protecting a garage, goods area, caravan etc.
Example of a help list request: USER HELP
Beeps
1x
2x
3x
4x
6x shortly
LED state
OFF
Permanently ON
Regular slow
flashing
Flashing fast
Interrupted light
Flashes after
turning the
ignition key on
- 2 -
Acoustic signals
Meaning
Arming
Disarming
Disarming after the alarm
Arming with the triggered
input
GSM network
available
LED indicator signals
Meaning
Disarmed
Connecting to a GSM network or a
phone call
Armed
GSM network is not available
Car was stopped (immobilization)
The number of flashes corresponds
to the number of controllers enrolled.
is not
MHF57000