TOTALINE A-i230NS User Manual page 2

I. Pump components
Exhausting Fitting
Housing
Sight Glass
Oil drain
II. Operating Manual
1. Before operating
All motors are designed for operating voltages plus or minus 10% of the normal
rating. Single voltage motors are supplied fully connected and ready to operate.
(a) Check the voltage and frequency at the outlet and ensure it matches the
specifications on the pump motor metal plate. Ensure that the ON-OFF switch is in
the OFF position before connecting the pump to a power source. Remove and
discard the exhaust plug from the exhaust fitting.
(b) Fill the oil reservoir with oil before activate the pump. Remove the Oil Fill cap and
add oil until oil show at the bottom of the sight glass. Refer to technical data in
manual for the correct oil capacity of pump.
(c) Place back the Oil Fill cap and remove the cap from the inlet fitting. Turn the motor
switch to ON position. Place back the cap on the inlet fitting when the pump runs
smoothly. This may takes 2 to 30 seconds depends on the ambient temperature.
After the pump operates for approximately one minute, check the sight glass for
proper oil level, which should be aligned with the sight glass Oil Level line. Refill oil if
necessary.
Note: The oil level should be aligned with the indicating line on the sight glass when
the pump is running. Insufficient oil filled will result in poor Vacuum performance.
Excessive of oil can result in overflowing of oil from the exhaust fitting.
USER MANUAL
Handle
Capacitor Box
Fan Cover
Motor
Base