Packet Handler Gui Limitations; Temperature Configuration Register Tab; Figure 27: Temperature Calibration Dialog Box; Table 3: Packet Log Descriptors - Semtech SX1233SKA User Manual

Packet Log Parameter
Time
Mode
RSSI
Pkt Max
Pkt #
Preamble Size
Sync
Length
Node Address
Message
CRC

5.5.4 Packet Handler GUI Limitations

When operating the packet handler via the SKA GUI, the user should be aware of the following limitations
associated with the GUI:
•
Minimum Preamble Size = 2 bytes
•
Maximum Packet Length = 66 bytes (64 bytes of data + Length byte + Address byte)

5.6 Temperature Configuration Register Tab

The Temperature Configuration Register Tab is illustrated below in Figure 29
to calibrate the SX1233 temperature sensor by clicking on the Calibrate button to access the temperature
calibration dialog box.
When the temperature sensor has been calibrate the temperature, as computed by the SX1233, will be
displayed, as illustrated in
Revision 1.0 STD – February 2010
© Semtech 2011
Description
Local (CPU) timestamp in MM:SS.S format for TX / RX packets
SX1233 Packet Mode
Indicated RSSI level (RX mode only)
Number of repeated packets set in GUI Control Window (0 = infinite)
Transmitted or received packet number
Size of transmitted or received preamble sequence
Sync Address
Payload length of TX / RX packet
node Address (optional)
Transmitted / received packet (can be viewed in GUI Message Window)
Transmitted / received CRC (optional)

Table 3: Packet Log Descriptors

Figure 28: Temperature Calibration Dialog Box
Figure 29 .
Page 24 of 31
SX1233SKA
USER GUIDE
. Note that user is prompted
Enter ambient
temperature here
www.semtech.com