Advertisement
1-800-227-1592 www.emergencycaller.com
3. Press 1 to enable channel selected in step #2 above. Press 2 to not
enable channel.
4. Press 2 to not accept an exit delay in your channel outgoing
message. We do not recommend a delay in any of your emergency
calls.
5. Press 2 to not accept an entry delay in your channel outgoing
message. We do not recommend a delay in any of your emergency
calls.
Program Channel NO or NC and MOM or CONT
1. Press 2 for NC (normally closed transmitter) – EC uses normally
closed vs normally open circuit
2. Press 1 for MOM (momentary transmitters) – EC uses Momentary vs
continuous transmission to save battery life
Outgoing Message Enable – Enables phone numbers to call and message
1. Press 1 to enable channel 1 outgoing message to dial number #1.
2. Press 1 to enable channel 1 outgoing message to dial number #2.
3. Press 1 to enable channel 1 outgoing message #1.
4. Press 1 to accept.
SELECT 1-4 TO ENABLE ADDITIONAL CHANNELS ON YOUR EC4 IF YOU
HAVE MORE THAN ONE PENDANT TRANSMITTER.
5. Press 0 or M to end Outgoing message enable or another Press 2 to
enable OGM for channel #2 (2-4) if applicable.
A message MIC Enabled Will Appear on display For A Few Seconds.
Advertisement
