Table of Contents
Advertisement
Figure 18. Pivoting the drive bay assembly downward
5. Reinstall the removed parts. To complete the replacement, see "Completing the parts replacement" on
page 47.
Replacing the storage drive
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 15.
3. Remove the front bezel. See "Replacing the front bezel" on page 16.
4. Pivot the drive bay assembly upward. See "Pivoting the drive bay assembly upward and downward" on
page 21.
5. Disconnect the signal cable and the power cable from the storage drive.
6. Replace the storage drive.
• 3.5-inch storage drive in the primary storage drive bay
22
V330–15IGM User Guide and Hardware Maintenance Manual
Advertisement
Table of Contents
