Kickstand
The kickstand
(Figure
the machine. Use the kickstand when you install or
remove the transport wheels or the cutting unit.
•
To use the kickstand to install the transport wheels,
lower the kickstand to the ground and step down
on the loop while pulling up and back on the
lower-center handle
CAUTION
The machine is heavy and can cause back
strain if lifted improperly.
Put your foot pressure down on the
kickstand loop and use only the
lower-center handle to raise the machine.
Attempting to raise the machine onto the
kickstand any other way can cause injury.
Figure 22
1. Lower-center handle
23) is mounted to the rear of
(Figure
22).
2. Kickstand loop
1. Kickstand
•
To prevent the machine from tipping backward
when removing the reel, lower the kickstand and
push in the locking pin to lock it in the S
position
(Figure
1. Kickstand—S
position
2. Locking pin
g018793
16
Figure 23
2. Kickstand loop
24).
Figure 24
3. Kickstand—S
TORAGE
position
g239955
ERVICE
g018142
ERVICE