Makita 4351CT Technical Information page 6

R
epair
7. Install Stop ring E-3 to secure Pin 4 as illustrated in Fig. 15.
8. Check whether Slider can reciprocate on Linear guides smoothly.
Note: If Slider does not reciprocate smoothly, Linear guides may lean to the left or the right.
Try again to assemble Linear guides correctly.
Fig. 15
9. Lubricate the parts assembled in Gear housing cover. Refer to [1] Lubrication in page 2.
10. Align Slider to Needle bearing 407 on crank complete, and then assemble Gear housing cover section to Gear housing
as illustrated in Fig. 16. Do not forget to assemble packing between Gear housing cover and Gear housing.
See Fig. 17.
Fig. 16
Fig. 17
Linear guide
Slider
Pin 4
Rod
Needle bearing 407
Slider
Gear housing
cover
Tapping screws CT 4x16
Gear housing cover
Safety wire
Stop ring E-3
Crank complete
Balance plate
Gear housing
Packing
P 6 / 15