Makita 4351CT Technical Information page 4

R
epair
[5] Disassembling Gear housing cover section
1. After separating Safety wire from Gear housing cover, remove four 4x16 Tapping screws CT .
Gear housing cover is separated from Gear housing as illustrated in Fig. 6.
Fig. 6
Tapping screws
CT 4x16
2. Remove Stop ring E-3 with slotted screwdriver.
Push Slider to the lower dead point. (Fig. 7)
Fig. 7
Slider
Pin 4
Rod
3. Slide Pin 4 in order to disconnect Rod with Slider. And then, pull out Rod from Gear housing cover.
Separate Linear guides from Gear housing by removing four M4x10 Pan head screws .
Pin 4, Slider and Leaf spring are disassembled from Gear housing cover. (Fig. 8)
Fig. 8
Linear guides
Slider
Pin 4
Note: When reassembling, be sure to the direction of Leaf spring illustrated above.
Gear housing cover
Gear housing
Stop ring E-3
Rod
Gear housing cover
Rod
Slider in the lower
dead point
Linear guides
Leaf spring
Slider
Pin 4
Pan head
screws M4x10
P 4 / 15