Honda CB1000RA Manual page 101

Remove the oil filter cover by removing
6.
the bolts and washers.
Remove the oil filter with a filter wrench
7.
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
Discard the oil and oil filter at an
u
approved recycling center.
Rubber
seal
Oil filter cover
Apply a thin coat of engine oil to the
8.
rubber seal of a new oil filter.
Oil filter
Bolts
Washer
Washer
Engine Oil Changing Engine Oil & Filter
u
Install the new oil filter and tighten.
9.
Torque: 19 lbf·ft (26 N·m, 2.7 kgf·m)
Install a new sealing washer onto the
10.
drain bolt. Tighten the drain bolt.
Torque: 22 lbf·ft (30 N·m, 3.1 kgf·m)
Fill the crankcase with the recommended oil
11.
( P. 84, P. 165) and install the oil fill cap.
2 2
Required oil
When changing oil & engine oil
filter:
3.2 US qt (3.0 L)
When changing oil only:
2.9 US qt (2.7 L)
Check the oil level.
12.
Check that there are no oil leaks.
13.
Install the parts in the reverse order of
14.
removal.
P. 96
2
99