Pump Priming Instructions - Sweetwater Spas Maxxus Owner's Manual

PUMP DOES NOT
OPERATE BUT
LIGHT DOES
OPERATE.
Pump Priming Instructions: Turn Hot Tub Off!
Remove filter and insert end of garden hose into filter pipe. Seal-off pipe
opening around hose using a large, clean rag and turn on maximum
water flow through the hose. After about 30 seconds, turn off water,
remove hose and rag, reinstall filter and activate pump's high speed.
IMPORTANT: If freezing conditions exist and pump is not operational,
take measures to protect the system from freeze damage. See
"Winterizing", page 22.
POOR JET ACTION
WATER IS TOO HOT
NO HEAT
Your authorized Sweetwater dealer is a trained service repair center. Should
checking the above steps fail to correct the problem, please call your dealer
so that he may arrange service.
Your Sweetwater dealer's phone number:
Sweetwater builds the best hot tubs in the industry. Nonetheless, we are
always striving to improve the quality and features of our products. Your input
as a Sweetwater hot tub owner is a cherished part of this process. If you have
Page 26
Depress "Jets" sensor.
1. If no sound is detected or if a "buzzing" sound is
detected, turn off power to the hot tub and contact
your dealer or service center.
2. If motor operates but no water flows to jets:
a. Pump may not be properly primed. See instruc-
tions on the next page.
b. Contact dealer or authorized service center.
1. Make certain the pump is on high speed.
2. Make sure jets are fully open.
3. Open air control for the jet system selected.
4. Check for adequate water level.
5. Check for dirty filter.
1. Reduce thermostat setting.
2. Reduce filtration cycle length. (Even without
heater on, water temperature can increase from
prolonged pump operation.)
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If "heater on" indicator is lit. but no temperature
rise is experienced after a reasonable period of
time, contact your dealer or authorized service
center.