Bali Service Connection (120 Vac); Power Supply Options And Requirements - Sweetwater Spas Maxxus Owner's Manual

Bali 120 VAC Service Connection
1. Remove the center cabinet panel directly under the hot tub's control panel.
2. Locate and unroll the GFI protected power cord.
3. Replace cabinet panel making sure cord passes through notch.
Refer to additional instructions in box on page 8.
* Power cord is not available for Canada - the hot tub must be hard wired.

Power Supply Options and Requirements

Sweetwater hot tubs are designed to provide optimum performance and flex-
ibility of use when connected to the maximum electrical service as listed
below. Bali is shipped configured for 120V, 15A connection with a GFI pro-
tected cord provided.
If you prefer, your Sweetwater dealer can perform a minor circuit board mod-
ification to allow the hot tub to accept different electrical service. The opera-
tional considerations of these modifications are listed in the footnotes located
at the end of this section.
PALERMO and BAHIA DOMESTIC MODELS (60 Hz)
Voltage
Current Draw
Number of Wires
Circuit Breaker
In 50A configuration, the heater will not operate while both the pumps are
operating at high speed.
ARUBA and CYPRUS DOMESTIC MODELS (60 Hz)
Voltage
Current Draw
Number of Wires
Circuit Breaker
Page 12
Table No. 1
*
240V/30A
240 volts
24 amps
Three
30 amp dual pole
*
240V/30A
240 volts
24 amps
Three
30 amp dual pole
240V/50A
240 volts
40 amps
Three
50 amp dual pole
240V/40A
240 volts
32 amps
Three
40 amp dual pole