Sweetwater Spas Maxxus Owner's Manual page 16

BALI DOMESTIC MODEL (60 Hz)
Voltage
Current Draw
No. of Wires Three (15 amp cord)
Circuit Breaker
PALERMO and BAHIA EXPORT MODELS (50 Hz)
Voltage
Current Draw
No. of Wires
Circuit Breaker
In 50A configuration, the heater will not operate while the pumps are oper-
ating at high speed.
ARUBA, BALI and CYPRUS EXPORT MODELS (50 Hz)
Voltage
Current Draw
No. of Wires
Circuit Breaker
In 40A configuration, the heater will operate while the pump is operating
at high speed. This also applies to export Palermo and Bahia 30A and
export Aruba, Bali and Cyprus 25A.
*
In this configuration, the heater will not operate at the same time as the
high speed of either pump. Note: Pump 2 in Palermo and Bahia models
runs only in high speed.
**
Bali Domestic Models Only (60 Hz) - For 240V connection of the Bali
move the red wire from position #1 to position #3 on the terminal block
(see Illustration 4, page 10).
***
Bali Domestic Models Only (60 Hz) - If the Bali is to be operated on
240 VAC, 40A service, remove the jumper at location JP1-1 on the circuit
board. 30A, 240 VAC operation increases the output capacity of the heater
four-fold compared to 120 VAC. However, the heater cannot operate when
the pump is on high speed. 40A, 240 VAC operation allows the heater to
operate at the same time as the high speed pump.
**
120V/15A 240V/30A
120 volts
12 amps
15 amp 30 amp dual pole
*
230V/25A
230 to 240 volts
18 amps
Three
25 amp dual pole
*
230V/20A
230 to 240 volts
14 amps
Three
20 amp dual pole
*
240V/40A
240 volts
22 amps
Four
40 amp dual pole
230V/30A
230 to 240 volts
24 amps
Three
30 amp dual pole
230V/30A
230 to 240 volts
20 amps
Three
25 amp dual pole
***
240 Volts
28 amps
Four
Page 13