Pedicraft Stay Safe Bed Operation Manual page 6

6 of 14
Figure 1
Assembly of the bed is easier with 2 people.
We recommend clean, rubber gloves be
used during assembly to keep the vinyl
padding as clean as possible.
Position the Mattress Deck on its side.
Place one End Frame on its side at one end
of the Mattress Deck. The padding identifies
the top of the frame.
Figure 2
Place the brackets of the Mattress Deck
through the End Frame one at a time past
the point where the holes line up.
Bring the bottom bracket back through the
End Frame and align the holes in the bracket
with the holes in the End Frame.
Figure 3
Pull the square tube of the End Frame over
the Mattress Deck bracket and align the
holes. The fit will be very snug.
Insert four 2" bolts and washers from the
outside of the frame and attach nuts. Do not
fully tighten.
Repeat to attach the second End Frame.
Figure 4
Attach the Bottom Frame to both End
Frames with four 2" bolts and washers.