Adjusting Volume And Audio Effects - Huawei ViewPoint 9000 Series User Manual

HUAWEI 9000
User Guide
Video
Output
Interface
HD OUT 1
HD OUT 2
SD OUT 1
According to the above table and your requirements, you can select which video to be output
through HD OUT 1, HD OUT 2, HD OUT 3, and SDI OUT respectively. Choosing Main
Menu > Conference Service > Manage Video Output. Then select available video to be
output through the three interfaces.
To show the desktop of a computer, e
are supported by the terminal. You can set these parameters by choosing Main Menu >
System Settings > Video Output.
4.4 Adjust g in Video Quality

4.5 Adjusting Volume and Audio Effects

You can press VOL
end.
Choose Ma
4.6 Switch ing the Screen Layout
You can change the layout
Alternatively, you can switch the layout by choosing the menus. Both methods can be used in
turn to change the layout.
Issue 05 (2009-11-12)
Available
Videos
①②③④
①②③④
Same as HD
OUT 1
To adjust the video effects, such as the brightness, choose Main Menu > Preference >
Video Effect.
Choose Main Menu > Preference > Picture Offset and use the right or left arrow key
to move the slider rightwards or leftwards gradually.
Choose Main Menu > Preference > Sampling Phase Adjustment and use the right or
left arrow key to move the slider rightwards or leftwards gradually.
After you adjust the video effects, the adjustment is applicable to only the local SD main-stream video.
/
in Menu > System Settings > Audio to adjust the audio output effects.
You can press SPEAKER
of the screen by pressing the dedicated keys on the remote control.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Combined Default Video
Picture Before
Conference
Show
①
Show
②
Show Same as HD OUT
1
nsure that the resolution and refresh rate of the computer
to increase or decrease the volume you hear at the local
to mute or unmute the speaker.
4 Controlling the Video and Audio
Default Video in
Conference
③
④
Same as HD OUT 1
4-5