Advertisement
Disassembly Procedure:
(See Figure 1 for Steps 1-6: Removing Outer Trim, Covers, and Panels)
1. Remove top trim from top front frame, using a small, flat blade screwdriver.
2. Remove 4 rear feet using a T10 Torx screwdriver.
3. Remove top cover using a T15 Torx screwdriver (one screw, at top of rear cover. Note that a
Posidrive screw was used on earlier units). Lift cover up and lift out.
4. Remove center screw in right side panel, using a T15 Torx (Note that a Posidrive screw was
used on earlier units).
5. Remove handle caps and handle straps from left side panel (1 screw on each end) using a T25
Torx screwdriver. Panel slides out.
6. Remove center screw in bottom panel and slide panel out.
ALL OF THE ABOVE PARTS WILL BE USED FOR REASSEMBLY
HP E2479A Upgrade Procedures
Figure 1. Removing Outer Trim, Covers, and Panels
4
Advertisement
