Advertisement
(See Figure 9 for Steps 17-20: Removing Side Fan and Fan/Disk Drive Bracket)
17. Remove side fan (4 screws) using a T15 Torx screwdriver. Unscrew fan and disconnect
power plug (may require pliers). Save fan and screws.
18. If you have a rear flexible disk drive (Model A), remove 4 screws using a T10 Torx
screwdriver and remove the rear flexible disk drive.
19. If you have a LAN option (Model B), remove the card (4 screws below fan opening and 2
screws on card inside) using a T10 Torx screwdriver. Disconnect cables and slide out. Card
and cables will not be reused.
20. Remove side fan/disk drive bracket (6 screws) using a T10 Torx screwdriver. Pull bracket
and slide out. Bracket will not be reused.
HP E2479A Upgrade Procedures
Figure 9. Removing Side Fan and Fan/Disk Drive Bracket
12
Advertisement
